文档下载
BAS16W数据表
参考设计(5)
SEPIC Converter Regulates 0.5A in LED String Reference Design
PMP8943: This wide input voltage range SEPIC operates from an input of 6V - 36V and regulates the current in a string of 8 LEDs to 0.5A. An external PWM input allows dimming over a wide duty cycle.
Low Vin Flyback Reference Design for High Voltage Laser Flash Drive
PMP10666: PMP10666 is a 12W isolated flyback design that supports very low Vin of 3.3V-6V and is capable of delivering 100mA at 120V output. The design uses LM3481 Boost controller IC which works on current mode operation and can be synchronized to any frequency between 100KHz to 1 MHz. This design was built on a 2 layer board and is a simple, low-BOM-count, and low-cost design providing an isolated output.
Low Vin, Small Form Factor Flyback Reference Design for High Voltage Laser Flash Drive
PMP10712: PMP10712 is a 1.2W, small form factor, isolated flyback design that supports very low Vin of 3.3V-6V and is capable of delivering 10mA at 120V output. The design uses LM3481 Boost controller IC which works on current mode operation and can be synchronized to any frequency between 100KHz to 1 MHz. This design was built on a 2 layer board and is a simple, low-BOM-count, and low-cost design providing an isolated output.
180W RGB LED Drivers for DLP Projector application
PMP4356: The PMP4356 is RGB LED drivers solution which used in high power density DLP projector. LM3434 and power block CSD87350 are used in each rail to provide up to 15A of drive ability. The design demostrates high efficiency up to 92.5%@full load within the form factor of 80mm*45mm*10.8mm with good dimming performance.
High Efficiency 12W Flyback Converter Operates at 1MHz Reference Design
PMP9648: This isolated flyback converter operates from an input of 36Vdc - 57Vdc and supplies an output of 12V@1A, while achieving an efficiency of nearly 90% at 1MHz.
