更多产品参数
Zener Diode, 5.6V V(Z), 5%, 0.2W, Silicon, Unidirectional, ROHS COMPLIANT, ULTRA SMALL, PLASTIC PACKAGE-2
制造商:
ACTIVE COMPNTS/DIODES
制造商型号:
MMSZ5232BS-7-F
符合标准:
Rohs 符合
不含铅
数据手册:
文档下载
MMSZ5232BS-7-F数据表
参考设计(4)
15 Cell Lithium Ion Battery Controller Analog Front End Reference Design
TIDA-00255: The TIDA00255 reference design utilizes the bq76940 analog front end (AFE) IC. It measures cell voltages, and die temperature or external thermistor voltage using a 14 bit ADC. Current is measured separately by a separate 16 bit coulomb counter. The design can turn off low side power FETs to stop discharge or charge based on selected hardware limits. A microcontroller not included in this design would be part of the battery controller to communicate to the AFE to set protection thresholds, turn on the power FETs, provide fault recovery and turn off the FETs for over or under temperature conditions. A battery controller design may contain other features which are not part of this reference design such as secondary over voltage protection, gauging, and isolated communication to let the system know the state of the battery.
Dual-Channel Full-Bridge Converter (54V @ 30A) for PoE Power Sourcing (PSE)
PMP6712: PMP6712 is a phase-shifted full-bridge converter capable of delivering 1600W of isolated output power and achieving efficiency of greater than 96%. This design uses the UCC28950 controller in a dual phase master-slave configuration. An LM5017 constant on-time synchronous buck regulator provides bias power to primary and secondary-side circuits using a coupled inductor with isolated flyback winding. The isolation voltage is specified as 2250VDC, allowing this design to be used as a system supply for Power Over Ethernet and other telecommunications applications.
Automotive Multi-Phase Synchronous Buck Power Module Reference Design
PMP10979: The PMP10979 is a highly efficient, multi-phase synchronous buck power module. The input voltage range is 11V to 24.30V, with an output of 13.50V at 95A. The design is intended for automotive applications.
Multi-Cell Battery Manager Unit with Integrated Charging, Gauging, Authentication and Protection
TIDA-00553: The Texas Instruments bq40z60 device is a Battery Pack Manager that integrates battery charging control output, gas gauging, and protection for completely autonomous operation of 2-series to 4-series cell Li-Ion and Li-Polymer battery packs. The architecture enables internal communication between the fuel gauging processor and battery charger controller to optimize the charging profile based on the external load conditions and power path source management during load transients and adaptor current limitations in the system. The charging current efficiency is scalable for power transfer based on the external components, such as the NFETs, inductor, and sensing resistor.
Bisco Industries
分销商编号：
未知
单价:
暂无价格信息
请输入数量：
-+
库存/包装：
56
起订量：
1
递增量：
1
搜索更多的分销商结果
搜索
请输入完整或部分产品型号，最少 3 个字母或数字
